Roll Roofing Installation Step By Step

Install a drip edge around the perimeter of the roof.

Roll roofing installation step by step.

Position the first course so it overhangs the drip edges by about 1 4 inch and roll it out a. Install drip edge and install 9 cant strips of roll roofing material along the rake and eaves edges gable ends and lower roof edge such that the roofing strip overhangs the roof deck by 1 4 to 3 8. Along the eave measure 35 1 2 inches and run the chalk line along this point. 10 easy steps for diy rolled roofing installation 1 spend some time cleaning the roof before beginning a rolled roofing installation project.

Spread the roofing cement along the. 3 take a roll of 18 inch wide roofing and use it to cover the length of the valley. Installing the rolled roofing 1. Cut the shingles to fit around the flange s dome.

Adhere the shingles adjacent to the flange with roofing tar. Use a trowel to scoop up the roofing cement. Nail the roofing strips parallel to the roof edge set in 1 and 8 from the roof edge with nails spaced 4 o c. If the plumbing vent is close to the peak of the roof lap the shingles over the peak of the roof.

Place the top edge of the roofing along the chalk line. Using a measuring tape measure 35 inches 89 cm up from. Prepare a valley between joined roofs by cutting a strip that is 18 inches wide and covers the entire length of the. Attach it to the valley with roofing nails spaced 6 inches apart about 3 4 inch from the edge.

Prepare roof edges cant strips. Mark a chalk line to identify the end of your first layer. The line will serve as the guide where the first metal sheet will be installed. Step by step roll roofing installation 1.

Apply roofing cement to the roof. Cut the rolled roofing. This aluminum flashing protects the edges of the roof sheathing. How to do it attach first course.

To seal a plumbing vent spread roofing. This should give you a 1 inch overhang on the eaves including the top edge of. Adhere the joint where the cut edges of the shingles meet the dome with roofing tar. Plan so that no two butt joints are closer than 2 feet from each other.