The tilt sensor signal is not being received by the controller.
Reset iris garage door opener.
Choose a hub for the device.
This is where the controller s connection wires should be connected to.
In this case resetting the door opener will de link it from your garage doors.
Additionally you can easily re link the garage opener to your doors if necessary.
Hold the pairing button until you get a long beep.
Likely you will have to cycle the door.
If the possible obstruction message still appears you will likely have to repair the tilt sensor with the gdc.
From the home screen touch the plus icon and select device.
Resetting newer openers most newer garage door openers function by learning the frequency of the handheld openers.
I bought a smartthing hub in hopes to get it working again.
While the hub searches press the connect button once.
It was originally connected to the iris hub.
Then verify you get open close status by tilting the sensor in your hand.
Press the remote button 2 more times to reset the opener.
To reset the system you will need to locate the button on the motor that reads learn or home in many cases this button will be located on the same side as the device s antenna and next to an led.
Unpair iris garage door opener.
Select iris and touch garage door.
This calibrates the opener and syncs it with your remote control.
However if you move homes get a new garage door or install a new garage door opener on your existing garage doors the remote door opener will no longer work.
I decided to go that route even though i had an insteon garage door kit just because of the all on issues going on and surely didn t want to have my garage door open in the middle of the night.
Then repair via the iris hub.
How can i unpair or reset the iris garage door opener.
Push down the same button on your garage door remote.
If you haven t already try removing and bringing the door sensor closer to the opener.
I was able to reset most of them except for these few.
Hi zeax i have one of those iris garage door controller and it s working fine.
Hollow000 april 26 2019 7 35pm 1.
Trace the wires from the garage door opener s pushbutton wall console to the door opener.
If true in this case it sounds like the door sensor isn t communicating to the controller.
I have the iris garage door opener and didn t unpair it before the iris shutdown.
You can try removing the gdc from the iris system that is done from the device tab then i would reset the gdc.
Iris garage door opener ge on off light switch ge outdoor plug first alert smoke co detector i tried to replace a v2 hub last night and unfortunately in the process i seem to have orphaned all of my devices.
Garage door opens or closes but the status does not change on the iris website or mobile app.
